Scopus
🔓 Açık Erişim YÖKSİS Eşleşti
Intrapulpal Thermal Changes during Setting Reaction of Glass Carbomer® Using Thermocure Lamp
BioMed Research International · Ocak 2016
YÖKSİS Kayıtları
Intrapulpal Thermal Changes during Setting Reaction of Glass Carbomer Using Thermocure Lamp
BioMed Research International · 2016 SCI-Expanded
PROFESÖR GÜL TOSUN →
Intrapulpal Thermal Changes during Setting Reaction of Glass Carbomer„ Using Thermocure Lamp
Biomed Research International · 2016 SCI-Expanded
DOÇENT FİRDEVS KAHVECİOĞLU →
Intrapulpal Thermal Changes during Setting Reaction of Glass Carbomer® Using Thermocure Lamp
BioMed Research International · 2016 SCI-Expanded
DOÇENT FİRDEVS KAHVECİOĞLU →
Intrapulpal Thermal Changes during Setting Reaction of Glass Carbomer Using Thermocure Lamp
BioMed Research International · 2016 SCI-Expanded
PROFESÖR HAYRİYE ESRA ÜLKER →
Makale Bilgileri
DergiBioMed Research International
Yayın TarihiOcak 2016
Cilt / Sayfa2016
Scopus ID2-s2.0-85008625577
Erişim🔓 Açık Erişim
Özet
Objectives. To measure the temperature increase induced during thermocure lamp setting reaction of glass carbomer and to compare it with those induced by visible light curing of a resin-modified glass ionomer and a polyacid-modified composite resin in primary and permanent teeth. Materials and Methods. Nonretentive class I cavities were prepared in extracted primary and permanent molars. Glass carbomer (GC) was placed in the cavity and set at 60°C for 60 sn using a special thermocure lamp. Resin-modified glass ionomer (RMGIC) and polyacid-modified composite resin (PMCR) were placed in the cavities and polymerized with an LED curing unit. Temperature increases during setting reactions were measured with a J-type thermocouple wire connected to a data logger. Data were examined using two-way analysis of variance and Tukey's honestly significant difference tests. Results. The use of GC resulted in temperature changes of 5.17 ± 0.92°C and 5.32 ± 0.90°C in primary and permanent teeth, respectively (p>0.05). Temperature increases were greatest in the GC group, differing significantly from those in the PMCR group (p<0.05). Conclusion. Temperature increases during polymerization and setting reactions of the materials were below the critical value in all groups. No difference was observed between primary and permanent teeth, regardless of the material used.
Yazarlar (3)
1
Firdevs Kahvecioğlu
ORCID: 0000-0003-4216-0849
2
Gül Tosun
ORCID: 0000-0003-4844-8157
3
H. E. Ülker
Kurumlar
Selçuk Üniversitesi
Selçuklu Turkey
Metrikler
5
Atıf
3
Yazar